Kohler KDI 1903M Workshop Manual page 154

11
3. Position the flange F on the crankcase K
inserting the gasket J, and inserting the gear H
up to the stop on the bearing L (Fig. 11.31).
4. Secure the flange F using the screws N
(tightening torque at 25 Nm).
Important
•
Always replace the gaskets P and Q at each
assembly.
5.
Insert the centring ring C in the flange F up to
the stop.
6. Insert the pump B on the flange F engaging the
gear H.
7. Secure the pump B using the screws A on the
flange F (tightening torque at 25 Nm).
EN 154
INFORMATION ABOUT OPTIONAL
COMPONENTS
Fig 11.18
Fig 11.19
Fig 11.20