Tightening Torques And The Use Of Sealants - Kohler KDI 1903M Workshop Manual

9
9. Check the tension of the belt S with the instrument
(DENSO BTG-2), positioning it in point P (the tension
must be between 200 and 230 N).
10. If the tension values do not correspond, tighten
screws A and D, then repeat operations 7, 8, 9 and
10.
9.14.3 Starter Motor
Important
•
Remove the tool if still there ST_34.
1.
Fit the starter Q with the screws R on to the flange
bell S (tightening torque of 45 Nm).

9.15 Tightening torques and the use of sealants

Tab. 9.4 - * Alternatively to the capscrew replacements, with "Dri-loc"
Breather room closing cover fastening capscrew (EXHAUST
Lower crankcase fastening capscrew
Lower crankcase fastening capscrew
Crankshaft gasket flange fastening capscrew
Closing cover fastening capscrew 3
EN 136
ASSEMBLY INFORMATION
BASE CONFIGURATION
Component
SIDE)
1st Cycle
2nd Cycle
3rd Cycle
1st Cycle
2nd Cycle
Connecting rod screw
1st Cycle
2nd Cycle
Idle gear lubr. hole cap closure
Fig 9.88
SHORT BLOCK
Thread
(mm)
M6x1
M12x1.25
M8x1.25
M8x1
M6x1
rd
M8x1.25
PTO
M14x1.5
Torque (Nm) Sealer
10
3 Torque
cycles
40
70
120
2 Torque
cycles
20
35
2 Torque
cycles
40
85
10
Loctite
25
2701*
Loctite
30
2701*