11
3.
Tighten the oil dipstick hose E using the screw D
on the manifold L (Tightening torque of 10 Nm).
NOTE: Check the integrity of the gaskets J.
4. Insert the dipstick B inside the hose E.
11.2 Heater (replacement)
Important
•
Before proceeding with operation, read
11.2.1 Disassembly
1. Undo the screws A and the relevant washers and
remove the earth cable B.
2. Remove the flange C and the manifold D.
3. Remove the heater E and the relevant gaskets F.
EN
146
INFORMATION ABOUT OPTIONAL
COMPONENTS
Par.
Fig 11.4
Fig 11.5
3.3.2.
Fig 11.6