Kohler KDI 1903M Workshop Manual page 150

11
11.4.2 Assembly
1. Secure the bracket N using the screws M on the
cylinder head P (tightening torque at 25 Nm).
2. Insert the screw H into the fixing hole on the
alternator L.
3. Insert the spacer R on the screw H (between the
alternator and crankcase).
4. Tighten the screw manually H onto the crankcase Q.
5. Orientate the second fixing hole of the alternator L
with the hole of the bracket N, secure the alternator L
using the screw G (tightening torque at 25 Nm) onto
the bracket N and then the screw H (tightening
torque at 25 Nm).
6. Insert the pin F in the plate slot E.
7. Orientate the pin F with the surface S (support for
screw A) upwards.
8. Secure the plate E using the screws D on the bracket
N (tightening torque at 25 Nm).
9. Insert the screw B in the plate C1 and pulley C.
10. Manually tighten the screw B onto the pin F up to the
stop; Undo the screw B again by one turn.
NOTE: The screw B must protrude by about 32 mm (A) from
the surface of the tightening pulley C (see detail X).
11. Install the new belt H (Fig. 11.10).
12. Tighten the screw A onto the plate E up to the stop
on the pin F.
13. Perform the operations from point 6 to 8 of Par.
11.3.
EN 150
INFORMATION ABOUT OPTIONAL
COMPONENTS
Fig 11.16
Fig 11.17
Fig 11.18
Fig 11.19