11
5. Clamp the fitting K (tightening torque at 45 Nm +
Loctite 2701).
6. Clamp the fitting H on the flange J inserting the
gasket U (tightening torque at 65 Nm).
7. Connect the hose B to the central fitting of support
M and of flange J.
8. Connect the hose C to the side fitting of the
support M and of head J.
9. Clamp the nuts A on the head J (tightening torque
at 48 Nm).
10. Clamp the nuts A on the support M (tightening
torque at 48 Nm).
Important
•
Check the tightening of the fittings H (Fig. 11.51)
and L (Fig. 11.52) (tightening torque at 65 Nm).
11.12 Intake circuit (replacement)
Important
•
Before proceeding with operation, read
3.3.2.
11.12.1 Air filter disassembly
1. Release the clamp B.
2. Untighten the screws A and remove the filter C.
EN
164
INFORMATION ABOUT OPTIONAL
COMPONENTS
Par.
Fig 11.52
Fig. 11.53