Table of Contents
Advertisement
TRENDnet User's Guide
Web Configuration
Advanced Settings > PoE > PD Alive Check
Parameter
Description
State
Enables/Disables the PD Alive Check.
Selects a port or a range of ports which you want to configure.
Port
State
Enables/Disables the PD Alive Check for the specific port(s).
IP Address
Specifies the Host IP address which connects to the port.
The interval to send the packet probes to check if the host is
Interval
still alive.
The retry times when no response from the host for the keep-
Retry Time
alive probe packet.
The action to the Power Device when the system detects that
Action
the Power Device cannot respond the keep-a-live probe packet.
The options have Reboot / Alarm / All /None.
© Copyright 2018 TRENDnet. All Rights Reserved.
When PD has been rebooted, the PoE port restored power after
Power Off Time
the Power Off Time time.
The Switch waits the Start Up Time to do PoE Auto Checking
Start Up Time
when the PD is rebooting.
Apply
Click Apply to take effect the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
PoE Schedule
The function has a global state configuration. If the global state configuration is
disabled. The Switch will not perform the schedule function. If the global state is
enabled, the Switch will check every port's configurations.
If the port's check configuration is NO for a specific day, the Switch will not perform
action for the specific port. If the port's check configuration is YES for a specific day, the
Switch will check the Start time and End Time. If the current time is in the interval
between Start time and End Time, the Switch will perform the action configuration. If
the action is ENABLE, the Switch will send power to the port. If the current time is not in
the interval between Start time and End Time, the Switch will not send power to the
port.
CLI Configuration
Node
Command
enable
show poe schedule port PORT_ID
interface
poe schedule (disable|enable)
interface
poe schedule week
(Sun|Mon|Tue|Wed|Thu|Fri|Sat)
check (yes|no)
Managed Industrial L2 Switch
Description
This command displays the PoE
port schedule configurations.
This command disables or enables
the PoE schedule on the specific
port.
This command enables or disables
the PoE schedule on the specific
day.
91
Advertisement
Table of Contents
