TRENDnet TI-RG262i User Manual page 93

TRENDnet User's Guide
PD Alive Check
The function has a global state configuration. If the global state configuration is
enabled. The Switch will check the configurations of every port.
If the port's state is enabled, the Switch will send keep-a-live probe packet every
interval time. If the host cannot respond when the keep-a-live probe packet count
is over the retry times, the Switch performs the action, reboot/alarm/all to the
Power Device, depending on the port's configuration.
Power OFF Time (sec):
When PD has been rebooted, the PoE port restored power after the
specified time.
Default:15, range: 3-120 sec.
Start up Time (sec):
When PD has been start up, the Switch will wait Start up time to do PoE
Auto Checking.
Default: 60, range: 30-600 sec.
Interval Time (sec):
Device will send checking message to PD each interval time.
Default: 30, range: 10-120 sec.
Action:
The action when the failure detection.
All: Send an alarm message to inform the administrator and then reboot
the PD.
Alarm: Just send an alarm message to inform the administrator.
None: Keep Ping the remote PD but does nothing further.
Reboot: Cut off the power of the PoE port, make PD rebooted.
© Copyright 2018 TRENDnet. All Rights Reserved.
CLI Configuration
Node Command
enable show pd-alive
configure pd-alive (disable|enable)
interface pd-alive action
(reboot|alarm|all|none)
interface pd-alive interval VALUE
interface pd-alive ip IP_ADDR
interface pd-alive retry-time VALUE
interface pd-alive power-off-time VALUE
startup-time VALUE
Managed Industrial L2 Switch
Description
This command displays the
configuration of the PD Alive Check.
This command disables or enables
the global PD Alive Check for the
Switch.
This command configures the
action when the system detects
that the host cannot respond the
keep-a-live probe packet.
This command configures the
interval to send the keep-a-live
probe packets to check if the host is
still alive for the specific port.
This command configures the Host
IP address which connects to the
specific port.
This command configures the retry
times when no response from the
host for the keep-a-live probe
packet for the specific port.
This command configures the
power-off time and startup time.
90