TRENDnet TI-RG262i User Manual page 122

TRENDnet User's Guide
Secondary This is the backup server used only when the Primary Radius
Server is down.
Radius Server
Apply Click Apply to add/modify the settings.
Click Refresh to begin configuring this screen afresh.
Refresh
Port Settings
Security > 802.1x > Port Settings
© Copyright 2018 TRENDnet. All Rights Reserved.
Parameter Description
Port
Select a port number to configure.
Select Enable to permit 802.1x authentication on the port.
802.1x State
You must first enable 802.1x authentication on the Switch
before configuring it on each port.
Select Both to drop incoming and outgoing packets on the port
when a user has not passed 802.1x port authentication.
Admin Control
Direction
Select In to drop only incoming packets on the port when a user
has not passed 802.1x port authentication.
Specify if a subscriber has to periodically re-enter his or her
Re-authentication
username and password to stay connected to the port.
Select Auto to require authentication on the port.
Select Force Authorized to always force this port to be
Port Control Mode authorized.
Select Force Unauthorized to always force this port to be
unauthorized. No packets can pass through this port.
Select Disable to disable Guest VLAN on the port.
Guest VLAN
Select Enable to enable Guest VLAN on the port.
Specify the amount of times the Switch will try to connect to
the authentication server before determining the server is
Max-req Time
down.
The acceptable range for this field is 1 to 10 times.
Specify how often a client has to re-enter his or her username
Reauth period and password to stay connected to the port. The acceptable
range for this field is 0 to 65535 seconds.
Specify a period of the time the client has to wait before the
next re-authentication attempt. This will prevent the Switch
Quiet period from becoming overloaded with continuous re-authentication
attempts from the client. The acceptable range for this field is
0 to 65535 seconds.
Managed Industrial L2 Switch
119