TRENDnet TI-RG262i User Manual page 29

TRENDnet User's Guide
The Node type:
⚫
enable
Its command prompt is "[DEVICE_NAME]#".
It means these commands can be executed in this command prompt.
⚫
configure
Its command prompt is "[DEVICE_NAME](config)#".
It means these commands can be executed in this command prompt.
In Enable code, executing command "configure terminal" enter the configure
node.
[DEVICE_NAME]# configure terminal
⚫
eth0
Its command prompt is "[DEVICE_NAME](config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface eth0" enter the eth0
interface node.
[DEVICE_NAME](config)#interface eth0
[DEVICE_NAME](config-if)#
⚫
interface
Its command prompt is "[DEVICE_NAME](config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface gigaethernet1/0/5" enter
the interface port 5 node.
Or
In Configure code, executing command "interface fastethernet1/0/5" enter
the interface port 5 node.
Note: depend on your port speed, gigaethernet1/0/5 for gigabit Ethernet
ports and fastethernet1/0/5 for fast Ethernet ports.
[DEVICE_NAME](config)#interface gigaethernet1/0/5
[DEVICE_NAME](config-if)#
© Copyright 2018 TRENDnet. All Rights Reserved.
⚫
vlan
Its command prompt is "[DEVICE_NAME](config-vlan)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "vlan 2" enter the vlan 2 node.
Note: where the "2" is the vlan ID.
[DEVICE_NAME](config)#vlan 2
[DEVICE_NAME](config-vlan)#
Managed Industrial L2 Switch
26