TRENDnet TI-RG262i User Manual page 83

TRENDnet User's Guide
System Priority LACP system priority is a number between 1 and 65,535. The
switch with the lowest system priority (and lowest port number
if system priority is the same) becomes the LACP "server". The
LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link
Aggregation Control Protocol (LACP). The smaller the number,
the higher the priority level.
Group LACP Select a trunk group ID and then select whether to Enable or
Disable Group Link Aggregation Control Protocol for that trunk
group.
Port Priority Select a port or a range of ports to configure its (their) LACP
priority.
Apply Click Apply to configure the settings.
Refresh Click this to reset the fields to the last setting.
LACP Group Status
Group ID The field identifies the LACP group ID.
State This field displays if the group has LACP enabled.
LACP Group Status
Port The field identifies the port ID.
Priority The field identifies the port's LACP priority.
© Copyright 2018 TRENDnet. All Rights Reserved.
LACP Info.
Advanced Settings > Link Aggregation > LACP Info.
Parameter Description
Group ID Select a LACP group that you want to view.
Neighbors Information
Port The LACP member port ID.
LACP system priority is used to determine link aggregation
group (LAG) membership, and to identify this device to other
System Priority
switches during LAG negotiations. (Range: 0-65535; Default:
32768)
System ID The neighbor Switch's system ID.
Port The direct connected port Id of the neighbor Switch.
The available time period of the neighbor Switch LACP
Age
information.
Port State The direct connected port's state of the neighbor Switch.
Port Priority The direct connected port's priority of the neighbor Switch.
Oper Key The Oper key of the LACP member port.
Managed Industrial L2 Switch
80