Table of Contents
Advertisement
TRENDnet User's Guide
configure
no loop-detection address
interface
loop-detection (disable | enable)
interface
no shutdown
interface
loop-detection recovery (disable
| enable)
interface
loop-detection recovery time
VALUE
configure
interface range
gigabitethernet1/0/ PORTLISTS
if-range
loop-detection (disable | enable)
if-range
loop-detection recovery (disable
| enable)
if-range
loop-detection recovery time
VALUE
Example:
[DEVICE_NAME](config)#loop-detection enable
[DEVICE_NAME](config)#interface 1/0/1
[DEVICE_NAME](config-if)#loop-detection enable
© Copyright 2018 TRENDnet. All Rights Reserved.
This command configures the
destination MAC to default
(00:0b:04:AA:AA:AB).
This command disables / enables
the loop detection on the port.
This command enables the port. It
can unblock port blocked by loop
detection.
This command enables / disables
the recovery function on the port.
This command configures the
recovery period time.
This command enters the interface
configure node.
This command disables / enables
the loop detection on the ports.
This command enables / disables
the recovery function on the port.
This command configures the
recovery period time.
Web Configuration
Advanced Settings > Loop Detection
Parameter
Description
State
Select this option to enable loop guard on the Switch.
Enter the destination MAC address the probe packets will be
MAC Address
sent to. If the port receives these same packets the port will be
shut down.
Port
Select a port on which to configure loop guard protection.
Managed Industrial L2 Switch
82
Advertisement
Table of Contents
