TRENDnet TI-RG262i User Manual page 55

TRENDnet User's Guide
The rate limitation is used to control the rate of traffic sent or received on a network
interface.
Rate Limitation unit: Mbs.
Default Settings
All ports' Ingress and Egress rate limitation are disabled.
CLI Configuration
Node Command
enable show bandwidth-limit
configure bandwidth-limit egress
RATE_LIMIT ports
PORTLISTS
configure no bandwidth-limit egress
ports PORTLISTS
configure bandwidth-limit ingress
RATE_LIMIT ports
PORTLISTS
configure no bandwidth-limit
ingress ports PORTLISTS
Example:
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#bandwidth-limit egress 1 ports 1-6
[DEVICE_NAME](config)#bandwidth-limit ingress 1 ports 1-6
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
This command displays the current rate
control configurations.
This command enables the bandwidth limit
for outgoing packets and set the limitation.
This command disables the bandwidth limit
for outgoing packets.
This command enables the bandwidth limit
for incoming packets and set the limitation.
This command disables the bandwidth limit
for incoming packets.
Web Configuration
Advanced Settings > Bandwidth Control > Rate Limitation > Bandwidth Limitation
Parameter Description
Port Selects a port that you want to configure.
Ingress Configures the rate limitation for the ingress packets.
Egress Configures the rate limitation for the egress packets.
Apply Click Apply to take effect the settings.
Refresh Click Refresh to begin configuring this screen afresh.
Managed Industrial L2 Switch
52