TRENDnet TI-RG262i User Manual page 61

TRENDnet User's Guide
The RIP version 2 group address, used to send routing information
224.0.0.9 using the RIP protocol to all RIP v2-aware routers on a network
segment
EIGRP group address. Used to send EIGRP routing information to all
224.0.0.10
EIGRP routers on a network segment
224.0.0.13 PIM Version 2 (Protocol Independent Multicast)
224.0.0.18 Virtual Router Redundancy Protocol
224.0.0.19 - 21 IS-IS over IP
224.0.0.22 IGMP Version 3 (Internet Group Management Protocol)
224.0.0.102 Hot Standby Router Protocol Version 2
224.0.0.251 Multicast DNS address
224.0.0.252 Link-local Multicast Name Resolution address
224.0.1.1 Network Time Protocol address
224.0.1.39 Cisco Auto-RP-Announce address
224.0.1.40 Cisco Auto-RP-Discovery address
224.0.1.41 H.323 Gatekeeper discovery address
CLI Configuration
Node Command
enable show mac-address-table
multicast
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
This command displays the current
static/dynamic multicast address
entries.
configure mac-address-table multicast
MACADDR vlan VLANID ports
PORTLIST
configure no mac-address-table
multicast MACADDR
Web Configuration
Advanced Settings > IGMP Snooping > Multicast Address
Parameter Description
VLAN ID Configures the VLAN that you want to configure.
MAC Configures the multicast MAC which will not be aged out.
Address Valid format is hh:hh:hh:hh:hh:hh.
Port Configures the member port for the multicast address.
Apply Click Apply to save your changes back to the Switch.
Refresh Click Refresh to begin configuring this screen afresh.
Managed Industrial L2 Switch
This command configures a static
multicast entry.
This command removes a static
multicast entry from the address table.
58