TRENDnet TI-RG262i User Manual page 100

TRENDnet User's Guide
interface no spanning-tree cost
spanning-tree port-priority <0-
interface
240>
interface no spanning-tree port-priority
interface range
configure
gigabitethernet1/0/PORTLISTS
if-range spanning-tree (disable|enable)
spanning-tree bpdufilter
if-range
(disable|enable)
spanning-tree bpduguard
if-range
(disable|enable)
spanning-tree rootguard
if-range
(disable|enable)
spanning-tree edge-port
if-range
(disable|enable)
if-range spanning-tree cost VALUE
© Copyright 2018 TRENDnet. All Rights Reserved.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-
200000000.
This command configures the path
cost to default for the specific port.
This command configures the port
priority for the specific port.
Default: 128.
This command configures the port
priority to default for the specific
port.
This command enters the interface
configure node.
This command configures
enables/disables the STP function
for the specific port.
This command configures
enables/disables the bpdufilter
function for the specific port.
This command configures
enables/disables the bpduguard
function for the specific port.
This command enables/disables the
BPDU Root guard port setting for
the specific port.
This command enables/disables the
edge port setting for the specific
port.
This command configures the cost
for the specific port.
Cost range:
if-range no spanning-tree cost
spanning-tree port-priority <0-
if-range
240>
if-range no spanning-tree port-priority
Web Configuration
Advanced Settings > STP > General Settings
Parameter Description
Select Enabled to use Spanning Tree Protocol (STP) or Rapid
State
Spanning Tree Protocol (RSTP).
Managed Industrial L2 Switch
16-bit based value range 1-65535,
32-bit based value range 1-
200000000.
This command configures the path
cost to default for the specific port.
This command configures the port
priority for the specific port.
Default: 128.
This command configures the port
priority to default for the specific
port.
97