TRENDnet TI-RG262i User Manual page 144

TRENDnet User's Guide
ONVIF
Management > Device Management > ONVIF
ONVIF is an open industry forum that provides and promotes standardized interfaces for
effective interoperability of IP-based physical security products.
The Switch use ONVIF to discovery if there is ONVIF device connected to the Switch.
The page show the detail information about ONVIF settings and ONVIF devices connected
to the Switch. The Switch displays ONVIF devices up to total port count, IEN-8428PL shows
upto 10 ONVIF devices connected to it. If one or more ONVIF devices are connected to
the same port it displays the last ONVIF device gets connect to it.
Important
Node Command
enable show onvif This command displays the onvif configurations.
enable show onvif This command displays all of the ports' neighbor
neighbor information.
This command enables onvif function on the
configure onvif enable
Switch.
configure onvif tx-interval This command configures the interval to transmit
the onvif packets.
configure onvif binding-ports This command binds the MAC address to a
particular port
configure no onvif tx-interval This command configures the onvif packets
transmit interval to the default value
configure no onvif binding- This command binds the MAC address to a
ports particular port
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
Web Configuration
Management > Device Management > ONVIF
Parameter Description
State Globally enables / disables the ONVIF on the Switch.
Sets the interval time in seconds when to send transmit ONVIF
Tx Interval
packets.
Managed Industrial L2 Switch
141