Jumbo Frame - TRENDnet TI-RG262i User Manual

TRENDnet User's Guide
Web Configuration
Basic Settings > General Settings > System
Configures a IPv4 address for your Switch in dotted decimal
IP Address
notation. For example, 192.168.10.200.
Enter the IP subnet mask of your Switch in dotted decimal
Subnet Mask
notation for example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted
Default Gateway
decimal notation, for example 192.168.10.1.

Jumbo Frame

Jumbo frames are Ethernet frames with a payload greater than 1500 bytes. Jumbo frames
can enhance data transmission efficiency in a network. The bigger the frame size, the
better the performance.
© Copyright 2018 TRENDnet. All Rights Reserved.
Notice:
The jumbo frame settings will apply to all ports.
If the size of a packet exceeds the jumbo frame size, the packet will be dropped.
The available values are 10240, 9216, 1552, 1536, 1522.
Default Settings
The default jumbo frame is 10240 bytes.
CLI Configuration
Node Command
enable show jumboframe
configure jumboframe
(10240|9216|1552|1536|1522)
Web Configuration
Basic Settings > General Settings > Jumbo Frame
Parameter Description
This field configures the maximum number of bytes of frame size
Frame Size
for specified port(s).
Apply Click this button to take effect the settings.
Refresh Click this button to reset the fields to the last setting.
Managed Industrial L2 Switch
Description
This command displays the
current jumbo frame settings.
This command configures the
maximum number of bytes of
frame size.
30