Mail Alarm - TRENDnet TI-RG262i User Manual

TRENDnet User's Guide
CLI Configuration
Node Command
enable
show auto-provision
configure auto-provision
auto- show
provision
auto- active
provision (enable|disable)
auto- server-address
provision IPADDR
auto- protocol
provision (tftp|http|ftp)
auto- FTP-user username
provision STRING password
STRING
auto- folder STRING
provision
auto- no folder
provision
auto- no FTP-user
provision
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
This command displays the current auto
provision configurations.
This command enters the auto-provision node.
This command displays the current auto
provision configurations.
This command enables/disables the auto
provision function.
This command configures the auto provision
server's IP.
The command configurations the upgrade
protocol.
The command configurations the username
and password for the FTP server.
The command configurations the folder for the
auto provision server.
The command configurations the folder to
default.
The command configurations the username
and password to default.
Web Configuration
Management > Auto Provision

Mail Alarm

The feature sends an e-mail trap to a predefined administrator when some events
occur. The events are listed below:
◆
System Reboot
◆
Port Link Change
◆
Configuration Change
◆
Firmware Upgrade
◆
User Login
◆
Port Blocked
Default Settings
Mail-Alarm Configuration:
-----------------------------------------------
State : Disabled.
Server IP : 0.0.0.0
Server Port : 25
Managed Industrial L2 Switch
: The system warn start or cold start.
: A port link up or down.
: The system configurations in the NV-RAM
have been updated.
: The system firmware image has been
updated.
: A user login the system.
: A port is blocked by looping detection or
BPDU guard.
131