TRENDnet TI-RG262i User Manual page 115

TRENDnet User's Guide
CLI Configuration
Node Command
enable
show access-list
configure access-list STRING iptype
(ipv4|ipv6)
configure no access-list STRING
acl show
acl action (disable|drop|permit)
acl action dscp remarking <0-63>
acl action 802.1p remarking <0-7>
acl 802.1p VALUE
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
This command displays all of the
access control profiles.
This command creates a new access
control profile.
Where the STRING is the profile
name. And you can specify the
type, ipv4 or ipv6.
This command deletes an access
control profile.
This command displays the current
access control profile.
This command actives this profile.
disable – disable the profile.
drop – If packets match the profile,
the packets will be dropped.
permit – If packets match the
profile, the packets will be
forwarded.
This command actives this profile
and specify that it is for DSCP
remark. And configures the new
DSCP value which will be override
to all packets matched this profile.
This command actives this profile
and specify that it is for 802.1p
remark. And configures the new
802.1p value which will be override
to all packets matched this profile.
This command configures the
802.1p value for the profile.
acl dscp VALUE
acl destination mac host MACADDR
acl destination mac MACADDR
MACADDR
acl destination mac MACADDR
MACADDR
acl no destination mac
acl ethertype STRING
acl no ethertype
acl source mac host MACADDR
acl source mac MACADDR
MACADDR
acl no source mac
acl source ip host IPADDR
Managed Industrial L2 Switch
This command configures the DSCP
value for the profile.
This command configures the
destination MAC and mask for the
profile.
This command configures the
destination MAC and mask for the
profile.
This command configures the
destination
MAC and mask for the profile. The
second MACADDR parameter is the
mask for the profile.
This command removes the
destination MAC from the profile.
This command configures the ether
type for the profile. Where the
STRING is a hexdecimal value. e.g.:
08AA.
This command removes the
limitation of the ether type from
the profile.
This command configures the
source MAC and mask for the
profile.
This command configures the
source AMC and mask for the
profile.
This command removes the source
MAC and mask from the profile.
This command configures the
source IP address for the profile.
112