TRENDnet TI-RG262i User Manual page 116

Managed industrial l2 switch
Table of Contents

Advertisement

TRENDnet User's Guide
acl
source ip IPADDR IPMASK
acl
no source ip
acl
destination ip host IPADDR
acl
destination ip IPADDR IPMASK
acl
no destination ip
acl
l4-source-port IPADDR
acl
no l4-source-port IPADDR
acl
L4-destination-port PORT
acl
no l4-destination-port
acl
vlan VLANID
acl
no vlan
acl
source interface PORT_ID
© Copyright 2018 TRENDnet. All Rights Reserved.
This command configures the
source IP address and mask for the
profile.
This command removes the source
IP address from the profile.
This command configures a specific
destination IP address for the
profile.
This command configures the
destination IP address and mask for
the profile.
This command removes the
destination IP address from the
profile.
This command configures UDP/TCP
source port for the profile.
This command removes the
UDP/TCP source port from the
profile.
This command configures the
UDP/TCP destination port for the
profile.
This command removes the
UDP/TCP destination port from the
profile.
This command configures the VLAN
for the profile.
This command removes the
limitation of the VLAN from the
profile.
This command configures the
source interface for the profile.
acl
no source interface PORT_ID
Where the MAC mask allows users to filter a range of MAC in the packets' source MAC
or destination MAC.
For example:
source mac 00:01:02:03:04:05 ff:ff:ff:ff:00
➔ The command will filter source MAC range from 00:01:02:03:00:00 to
00:01:02:03:ff:ff
Where the IPMASK mask allows users to filter a range of IP in the packets' source IP or
destination IP.
For example:
source ip 172.20.1.1 255.255.0.0
➔ The command will filter source IP range from 172.20.0.0 to 172.20.255.255
Example:
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#access-list 111
[DEVICE_NAME](config-acl)#vlan 2
[DEVICE_NAME](config-acl)#source interface 1
[DEVICE_NAME](config-acl)#show
Profile Name: 111
Activate: disabled
VLAN: 2
Source Interface: 1
Destination MAC Address: any
Source MAC Address: any
Managed Industrial L2 Switch
This command removes the source
interface from the profile.
113

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ti-rp262i

Table of Contents