Table of Contents
Advertisement
TRENDnet User's Guide
Example:
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#snmp enable
[DEVICE_NAME](config)#snmp community public rw trusted-host
192.168.200.106/24
[DEVICE_NAME](config)#snmp trap-receiver 192.168.200.106 v2c public
[DEVICE_NAME](config)#snmp system-contact IT engineer
[DEVICE_NAME](config)#snmp system-location Branch-Office
Web Configuration
SNMP Setting
Management > SNMP > SNMP > SNMP Settings
Parameter
Description
Select Enable to activate SNMP on the Switch.
SNMP State
Select Disable to not use SNMP on the Switch.
Type
a
System Name
(The System Name is same as the host name)
System Location
Type a System Location for the Switch.
© Copyright 2018 TRENDnet. All Rights Reserved.
System
Name
for
the
System Contact
Apply
Refresh
Community Name
Management > SNMP > SNMP > Community Name
Parameter
Community
String
Switch.
Rights
Managed Industrial L2 Switch
Type a System Contact for the Switch.
Click Apply to configure the settings.
Click this button to reset the fields to the last setting.
Description
Enter a Community string, this will act as a password for requests
from the management station.
An SNMP community string is a text string that acts as a password.
It is used to authenticate messages that are sent between the
management station (the SNMP manager) and the device (the
SNMP agent). The community string is included in every packet
that is transmitted between the SNMP manager and the SNMP
agent.
Select Read-Only to allow the SNMP manager using this string to
collect information from the Switch.
Select Read-Write to allow the SNMP manager using this string to
create or edit MIBs (configure settings on the Switch).
128
Advertisement
Table of Contents
