TRENDnet TI-RG262i User Manual page 82

TRENDnet User's Guide
interface no lacp port_priority
configure interface range
gigabitethernet1/0/PORTLISTS
if-range lacp port_priority <1-65535>
if-range no lacp port_priority
© Copyright 2018 TRENDnet. All Rights Reserved.
This command configures the
default for the priority for the
specific port.
This command enters the interface
configure node.
This command configures the
priority for the specific ports.
Note: The default value is 32768.
This command configures the
default for the priority for the
specific ports.
Web Configuration
LACP Settings
Advanced Settings > Link Aggregation > LACP
Parameter Description
Select Enable from the drop down box to enable Link
Aggregation Control Protocol (LACP).
State
Select Disable to not use LACP.
Managed Industrial L2 Switch
79