Names And Functions; Panel Description - Toshiba TOSVERT VF-P7 Instruction Manual

1.3 Names and functions

1.3.1 Panel description

VEC lamp
Lit when the Inverter
is in vector control
mode.
ECN lamp
Lit when the inverter
is in energy-saving
mode.
RUN key lamp
Lit when the RUN key
is enabled.
RUN key
Pressing this key
while the RUN key is
lit starts the motor.
UP/DOWN key lam
With these keys, you
can set the operation
frequency while the
UP/DOWN lamp is lit.
CHARGE lamp
Indicates that a high voltage
remains in the inverter. Do not
open the terminal board cover
for safety while this lamp is lit.
Cover for common serial
option connectors
To use connectors reserved
for options, detach this
cover by sliding it to the
right.
･ Parameter writer
･ Extension panel, etc.
Cover for serial RS485
connectors
To use an RS485 connector,
detach this cover by sliding it to
the right.(Refer to 2.3.3)
RUN lamp
Lit when the inverter is in
operation or blinks when It
is in auto acceleration/
deceleration mode.
[ Front view ]
Connector for options
Used to install the following options:
･ Expansion TB option unit
･ Vector option unit
･ F10M option unit
･ S20 option unit
･ PG feed back board, etc.
Terminal board cover fixing screws
A-2
MON lamp
Lit when the inverter
Lit when the
is in parameter
inverter is in
setting mode.
monitor mode.
Pressing this key
while the RUN key
lump is lit causes
the motor to make a
slowdown stop.
Optional board
Used to install the
following options:
･ PG feedback options
Terminal board cover
Be sure to attach the cover
before starting the
operation to prevent
persons from touching the
terminal board in error.
PRG lamp
STOP key
MONITOR key
Used to display the
operation frequency,
parameter setting
error messages, etc.
ENTER key
DOWN key
UP key
Pushing mark,
make this cover
slide to the right.
Sink/source
switching