Toshiba TOSVERT VF-P7 Instruction Manual page 139

Torque limits can be set with the parameters  and .
[Positive torque limit]
(Selection of power running torque limit #1) :Set at (  )
(Power running torque limit #1)
[Negative torque limit]
(Selection of regenerative torque limit #1)
(Regenerative torque limit #1)
■Parameter setting
Title
Selection of power running

torque limit #1
Power running torque limit #1

Selection of regenerative

torque limit #1
Regenerative torque limit #1

With these parameters, you can set 4 patterns of positive torque limits and 4 patterns of
negative torque limits. Refer to 7.2 for the setting for switching from the terminal board.
Power running torque limit #1− Regenerative torque limit #1−
Power running torque limit #2− Regenerative torque limit #2−
Power running torque limit #3− Regenerative torque limit #3−
Power running torque limit #4− Regenerative torque limit #4−
Note) If the value set with  (stall prevention level) is smaller than the torque limit, then
the value set with  acts as the torque limit.
b) Limiting the torque with external signals
Reverse
The torque limits can be changed arbitrarily by means of external signals.
Function
: VI(voltage) / II(current)
: RR(volume / voltage)
: RX(voltage)
: RX2(voltage)(optional)
: 
  ∼  [%],   : Invalid
: VI(voltage) / II(current)
: RR(volume/ voltage)
: RX(voltage)
: RX2(voltage)(optional)
: 
  ∼  [%],   : invalid
Positive
Regenerative Power running
Power running Regenerative
Negative
F-47
:Set a desirable torque limit level.
:Set at (  )
:Set a desirable torque limit level.
Adjustment range
Forward
Default setting



