Toshiba TOSVERT VF-P7 Instruction Manual page 196

No. Option name
RS-232C
⑭ communication
converter cable
RS-485 communication
converter unit
⑮
(for communication with
multiple inverters)
⑯ Communication cable
⑰ Remote control panel
⑱ Application control units
Harmonic suppression
converter
⑲
Power regeneration
converter
Option ⑩∼⑮ should be used under the condition of 9600 bps or less ().
Function, purpose.
If this unit is used to connect the inverter and a personal computer and so on with each other, data communication can
be performed between the two besides easy adjustment of parameters, saving and writing data.
<Outline drawings with dimensions>
RJ45 connector
(Model: RS20035)
More than one inverter can be controlled with a personal computer and so on if this unit is
used for connection between inverters and personal computer.
･Computer link: Since this unit makes it possible to connect inverters with higher-class
computer, FA computer, etc., a data communication network can be
constructed among multiple inverters.
･Communication among inverters: For the purpose of proportional operation of multiple
<Outline drawings with dimensions>
(Model: RS4001Z)
Connection cable for connecting parameter writer, extension control panel,
RS-232C communication units, and RS-485 communication units.
Cable types: CAB0011 (1 m), CAB0013 (3 m), CAB0015 (5 m).
A frequency meter, frequency setup device, RUN/STOP (forward, reverse) switch
are built in this operation panel. (Model: CBVR-7B)
Applied control units of the AP series make various applied control possible if they
are used in combination with the inverter.
■ Proportional control panel (APP-2B)
■ Ratio setup panel (APH-7B)
■ Regulated power supply board (APV-2B)
■ Cushion starter panel (APC-2B)
■ Synchronizing control panel
(APS-2B1)
■ Synchronizing transmitter (DRR-2)
■ Remote control panel (APM-2B)
･ Higher harmonic suppressor unit improves input power-factor by suppressing
harmonic current.
･ Power regenerator unit protects the inverter from load sprung from frequent rapid
deceleration and negative torque.
For applicable models and particulars, inquire at our office.
I-8
5m
D-Sub 9pin connector
inverters, a frequency data communication network can
be constructed among multiple inverters.
２５
１６.５
Ｒ２.５
Ｒ２.５
８.５
４ １
３０
(Model: RS4002Z)
■ Process control panel with built-in PI
controller (APJ-2B)
■ TG follower panel (APF-7B)
■ Current detection panel (APD-2B)
■ Torque control panel (APL-2B)
■ FV converter (APR-2B)
■ Loop controller (APU-2B)
１００
５