6.6 Speed/torque command gain and bias
6.6.1 Using two types of frequency (speed) commands
:Speed setting mode selection
:Reference priority selection
:Speed setting mode selection #2
:/ switching frequency
・Function
These parameters switch two types of frequency
・ Switching by parameter setting
・ Automatic switching by means of switching frequencies
・ Switching with input terminal
1) One frequency (speed) reference
Reference priority selection =(Default setting)
Priority is given to the reference set with .
2)
Switching with input terminal (
Reference can be switched if the frequency priority switching function is assigned to a terminal.
A:
B:
Ex.) When the frequency priority switching function is assigned to terminal S4.
Title
S4
CC
――
has priority
――
has priority
Function
Input terminal selection #8(S4)
OFF
ON
=)
A
B
Frequency priority switching terminal OFF
Frequency priority switching terminal ON
Adjustment range
∼
Reference priority
has priority
has priority
F-11
Frequency(speed) reference
Frequency reference
Setting value
(Frequency reference
priority switching)