Toshiba TOSVERT VF-P7 Instruction Manual page 174

Parameter setting
Positive Negative Function
logic logic
38 39 PID deviation limit
40 41 Run/stop
42 43 Serious failure
44 45 Light failure
Commercial/INV
switching output #1
46 47
(for inverter operation
output)
Commercial/INV
switching output #2
48 49
(for commercial
operation output)
50 51 Cooling fan ON/OFF
52 53 In Jog run
Panel operation/terminal
54 55 board operation
switching
Cumulative operation
56 57
time alarm
Abnormal communication
58 59 alarm #1
(caused by scanning)
Forward/reverse
60 61
switching
62 63 Ready for operation #1
64 65 Ready for operation #2
Poor control power supply
66 67
() pre-alarm
System consistent
68 69 sequence
(BR: Brake release)
70 71 In (pre-)alarm status
Forward speed limit
72 73
(torque control)
Reverse speed limit
74 75
(torque control)
76 77 Inverter healthy output
Abnormal communication
alarm #2 (caused by
78 79
RS485 logic or
message transmission)
80 81 Error code output #1
82 83 Error code output #2
84 85 Error code output #3
86 87 Error code output #4
88 89 Error code output #5
90 91 Error code output #6
Operation output specifications (in case of positive logic)
"ON": PID deviation is in  or  set value.
"ON": Running frequency is output or DC injection breaking ()
is performed.
"ON": Serious failure(, , , phase failure, abnormal
output, short-circuit) is detected.
"OFF": Inverter has recovered from serious failure. (Serious failure
has been reset)
"ON": Light failure (, , , , ) is detected.
"OFF": Inverter has recovered from light failure. (Light failure has
been reset)
Refer to 6.16.
Refer to 6.16.
"ON": Cooling fan is in operation.
"OFF": Cooling fan is off operation.
"ON": In jog run.
"OFF": In normal operation.
"ON": In operation by terminal board.
"OFF": In operation by control panel.
"ON": Cumulative operation time is beyond the  set value.
"OFF": Cumulative operation time is less than the  set value.
"ON": Communication error caused by scanning has occurred.
"OFF": Communication error is cancelled (reset).
"OFF": In forward operation.
"ON": In reverse operation.
(The last status is held while operation is suspended.)
"ON": In operable status or operation can be started with frequency
command input as an operation switching answer-back.
"OFF": In inoperable status.
"ON": In operable status or operation can be started with ST and
RUN signals and frequency command input
"OFF": In inoperable status.
"ON": Control circuit under-voltage is detected ().
(detection level; 200V class: approx. 145 VAC or lower,
400V class: approx. 290 VAC or lower)
Output the braking signal according to the brake sequence.
"ON": More than one of alarm, pre-alarm, under-voltage, low
current over-torque, poor control power supply, PID deviation
limit, abnormal frequency setting or torque limit have occurred
or detected.
"OFF": All the alarms above are cancelled.
"ON": Forward operation speed is  set value or over.
"OFF": Forward operation speed is less than  set value.
"ON": Reverse operation speed is  set value or over.
"OFF": Reverse operation speed is less than  set value.
"ON" and "OFF" are alternately output at intervals of 1 second.
"ON": Communication error caused by RS485 logic or message
transmission has occurred.
"OFF": Communication error is cancelled (reset).
Output the failure code in 6bits.
G-7