6.23.2 Switching of acceleration/deceleration #1, 2, 3 and 4
:Acceleration time #2
:Deceleration time #2
:Acc/dec #1,2,3,4 selection
:Acc/dec switching frequency #1
:Acceleration time #3
:Deceleration time #3
:Acc/dec switching frequency #2
・Function
With these parameters, you can set 4 acceleration and deceleration times. Acceleration
and deceleration times can be selected or switched by any of the following 3 method:
1) Selection with parameters
2) Switching by means of frequencies
3) Switching with terminals
Title
Acceleration time #2
Deceleration time #2
Acc/dec time #1, 2, 3, 4
selection
Acceleration time #3
Deceleration time #3
Acceleration time #4
Deceleration time #4
1) Selection with parameters
Output frequency [Hz]
=
=
=
=
The acceleration/deceleration time selection parameter has been set at 1 by default. The setting
of can be changed from to , or . (The setting of is valid when is
set at 1.)
Function
0
:Acceleration time #4
:Deceleration time #4
:Acc/dec switching frequency #3
:Acc/dec pattern #2
:Acc/dec pattern #3
:Acc/dec pattern #4
Adjustment range
()∼ [s]
()∼ [s]
: Acc/dec #1, : Acc/dec #2,
: Acc/dec #3, : Acc/dec #4
()∼ [s]
()∼ [s]
()∼ [s]
()∼ [s]
F-50
Default setting
Model dependent
Model dependent
Model dependent
Model dependent
Model dependent
Model dependent
time [s]