Pattern Run - Toshiba TOSVERT VF-P7 Instruction Manual

6.24 Pattern run

 ：Pattern run selection
 ：Pattern run mode
 ,
 ∼  ：Pattern group #1 selection #1∼#8
 ∼  ：Pattern group #2 selection #1∼#8
 ∼  ：Pattern group #3 selection #1∼#8
 ∼  ：Pattern group #4 selection #1∼#8
 ∼  ：Preset-speed #1∼#15 operation continuation mode
 ∼  ：Preset-speed #1 to #15 operation time
・Function
These parameters enable you to form up to 60 patterns of automatic operation by variously
combining operation frequencies, operation times and acceleration/deceleration times.
1) Start-up by control panel operation(＝) : up to 15 patterns
2) Start-up by terminal board operation(＝): up to 60 patterns (15 types x 4 patterns)
Note) When control is exercised by the operation panel, pattern group #1 is always selected. If you
want to operate in a pattern other than pattern group #1, select pattern group #1, #2, #3 or #4 ,
using input terminal selection parameters (∼).
[Parameter setting]
Title
Pattern run

selection
Pattern run mode

Cycle number of

pattern group #1
Pattern group #1

∼ selection #1∼#8
Cycle number of

pattern group #2
Pattern group #2

selection #1∼#8
∼
Cycle number of

pattern group #3
Pattern group #3

selection #1∼#8
∼
Cycle number of

pattern group #4
 Pattern group #4
selection #1∼#8
∼
Preset-speed
#1∼#15

operation
∼
continuation
mode
Preset-speed

#1∼#15
∼
operation time
＊Forward/reverse, Acc/Dec time #1/#2, V/f control mode #1/#2 can be set with ∼
(Preset-speed operation frequency #1 to #15 control modes). Refer to 5.14 for details.
Note) When the function of auto-restart is active, the time spent for speed search is added to the operation
time set for pattern operation. Consequently, the effective operation time sometimes becomes
shorter than the settled operation time.
 ,  ,
Function
: Disabled, : Enabled
: Patterned operation canceled during stop
: Patterned operation continued during stop
∼, : ∞
: Skip,  to 
1∼, : ∞
: Skip,  to 
1∼, : ∞
: Skip,  to 
1∼, : ∞
: Skip,  to 
: Operation time in second after start of operation
: Operation time in minute after start of operation
: Operation time in second after attainment of frequency
: Operation time in minute after attainment of frequency
: Infinite (continued until stop command is entered)
: Continue until next step command
∼ [s]/[min]
(The unit depends on )
 ：Cycle number of pattern group #1 to #4
Adjustment range
F-53
Default
setting



∼

∼,


∼

∼,


