Changing Items Displayed In Status Monitor Mode; Switching Basic Parameters - Toshiba TOSVERT VF-P7 Instruction Manual

Title
Decimal place number of
Acceleration/deceleration

time

6.29.5 Changing items displayed in status monitor mode

 ：Monitor display mode setting
 ：Status monitor #1 display mode
 ：Status monitor #2 display mode
 ：Status monitor #3 display mode
 ：Status monitor #4 display mode
These parameters are used to select the item to be displayed when the power is turned on and
also to change items displayed in status monitor mode. Refer to 8.1 for details.

6.29.6 Switching basic parameters

 ：Selection of panel V/f1, 2, 3 or 4
・Function
This parameter is used to switch V/f characteristics during operation or to drive
four motors with a single inverter.
This parameter is valid only when the inverter is in panel operation mode.
[Parameter setting]
V/f1 is selected default setting.
Title

[Parameters which can be switched with ]
Base frequency #1
Base frequency voltage #1
Manual torque boost
Motor overload protection level #1
Base frequency #3
Base frequency voltage #3
Manual torque boost #3
Motor overload protection level #3
: Parameter groups selected by default
■Switching by means of terminals
The V/f1, 2, 3 and 4 can also be switched by switching on and off terminals.
⇒Refer to 6.4.1 for details.
Function
Function
Selection of panel
V/f1,2,3 or 4
(V/f1)




(V/f3)




Adjustment Default
range setting
: 1 [s]
: 0.1 [s]
: 0.01 [s]
Adjustment range
1: V/f1, 2: V/f2,
3: V/f3, 4: V/f4
Base frequency #2
Base frequency voltage #2
Manual torque boost #2
Motor overload protection level #2
Base frequency #4
Base frequency voltage #4
Manual torque boost #4
Motor overload protection level #4
F-67
Value displayed after
change (example)

 

Default setting

(V/f2)




(V/f4)



