Toshiba TOSVERT VF-P7 Instruction Manual page 147

∼(Preset-speed #1 to #15 operation continuation mode)
Output frequency [Hz]
Setting frequency
F-CC
∼(Preset-speed #1 to #15 operation continuation mode)
Output frequency [Hz]
Setting frequency
Step trigger signal
Set the input terminal selection
★
Notes)
・ Pattern operation groups should be selected by terminal input.
・ When the operation command mode selection is set for panel operation, pattern group #1 is always
selected.(If you need a pattern other than pattern group #1, set input terminal selection (∼
) at  to , and operate with the terminal input.)
・
If no signal is put out from any pattern run signal (all terminals are turned off), or after the
pattern run is completed, the system returns to the normal operation mode
・
When two or more pattern group numbers are entered simultaneously, the pattern group operations
are performed in ascending order and automatically switched to one another. In this case, it may
take about 0.06 seconds to search for each pattern.
･ 10 milliseconds after a pattern operation group selection #1, 2, 3 or 4 is activated, turn on the
operation signal (F-CC). Within 10 [ms] or less, a signal for ordinary operation may be put out.
Pattern group #1(S1-CC)
Pattern group #2(S2-CC)
Pattern group #3(S3-CC)
Pattern group #4(S4-CC)
= (Infinite(continued until stop command is entered))
0
=  (Continue until next step command)
0
∼
Pattern run operation
① ③ ① ② ③ ④
ON
ON
F-55
 ＝
 ＝
[s]
ON
OFF
[s]
ON
OFF
at (or ): pattern run trigger signal.
 
① ：select pattern group #1
② ：select pattern group #2
③ ：select pattern group #3
④ ：select pattern group #4
ON
<Parameter setting>
=(Pattern group #1)
ON
=(Pattern group #2)
ON
=(Pattern group #3)
=(Pattern group #4)
ON
.