Nortel Media Gateway 1000E PRI Installation And Comissioning Manual page 65

•
•
•
You do not need to enter other configuration information on the MGC.
All other information necessary to the operation of the PRI Gateway is
configured through Element Manager and is automatically downloaded
to the MGC from the Call Server.
After configuration is complete and the MGC has rebooted, the MGC
attempts to register to the Call Server. The Call Server then attempts to
match the IP address configured in LD 97 for this PRI Gateway against the
IP address included in the registration request. If either of these checks
fail, appropriate error messages are displayed. For more information,
see
messages" (page
MGC configuration information is entered two ways:
•
•
Here is an example of the configuration of an MGC without any installed
DSP daughterboards:
Please define the data networking parameters for this
MG 1000E now.
ELAN IP : 47.11.216.79
ELAN subnet mask :
ELAN gateway IP : 47.11.216.1
Primary CS IP : 47.11.216.61
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007, Nortel Networks
.
The TLAN configuration of the IPMG (through Element Manager):
— IP address
— subnet mask
— default gateway address
Information for the Call Server controlling the PRI Gateway:
— hostname of the Call Server on the ELAN subnet [optional through
Element Manager]
— IP address of the Primary Call Server
Hostname for the PRI Gateway:
— hostname of the IPMG [optional through Element Manager]
Appendix "Media Gateway Controller system alarms, events, and
153).
If the MGC detects that no IP configuration exists, the setup menu
appears.
Through the mgcsetup shell command.
Note: Any changes to the configuration of the MGC ELAN must be
reflected in similar changes on the Call Server.
Nortel Communication Server 1000
NN43041-311 01.01 Standard
Release 5.0 30 May 2007
Configure the Media Gateway Controller 65
255.255.254.0