Table of Contents
Advertisement
116 Configure an E1/T1 card
3
4
5
6
7
8
Configure ISDN E1/T1 trunks
To define the parameters for the ISDN E1/T1 trunks, see
"Configuring ISDN E1/T1 trunks" (page
used by the E1/T1 card to shorten alarm conditions if the card is recovered
from power-up or restarts.
Procedure 45
Configuring ISDN E1/T1 trunks
Step
1
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007, Nortel Networks
.
The E1/T1 card uses this address to receive the time and date from
the Media Gateway Controller.
In the System Name field, type up to 15 alphanumeric characters
for the name of the system.
In the IP address of E-mail Server field, type the IP address.
The E1/T1 card uses this address to send system backup files. If
this field is left empty or is incorrect, the E1/T1 card does not send
e-mail messages. However, the rest of the system operates properly.
Note: The E1/T1 card uses SMTP. The e-mail server must
support this protocol.
In the From E-mail address field, type the e-mail address that the
E1/T1 card uses to identify itself (the default is MGP@company.com).
This is the e-mail address that appears in the From field of a received
e-mail; some e-mail servers require this information.
In the Administrator E-mail address field, type the e-mail address to
which the backup files are sent (the default is admin@company.com).
In the Outdated Reports field, select the number of days that the
E1/T1 card keeps date-related files before they are deleted. The
range is 0 to 120 days. If you select 0, the files are deleted at the
end of the day.
To save the settings, click Submit.
Action
On the Home - System Overview screen, select System Settings
> E1/T1 ISDN Settings on the left pane.
The window shown in
117)
appears.
Nortel Communication Server 1000
NN43041-311 01.01 Standard
Release 5.0 30 May 2007
—End—
116). This basic configuration is
Figure 29 "E1/T1 Settings window" (page
Procedure 45
Advertisement
Table of Contents
