Configure The Media Gateway Controller And Dsp Daughterboards In A Pri Gateway; Introduction; Configure The Media Gateway Controller On The Call Server - Nortel Media Gateway 1000E PRI Installation And Comissioning Manual

Configure the Media Gateway Controller
and DSP daughterboards in a PRI
Gateway
This chapter contains information about the following topics:
•
•
•
•

Introduction

Following installation of the PRI Gateway chassis, the Media Gateway
Controller (MGC) and associated peripheral cards, two tasks must be
carried out before the MGC can register to the CS 1000E Call Server:
•
•
The order of these tasks is not critical. However, Nortel recommends that
you configure the MGC on the Call Server before you install the MGC.
You also configure the DSP daughterboards to support Voice Gateway
Channels.
Configure the Media Gateway Controller on the Call Server
To configure the MGC on the Call Server, follow the steps in:
•
•
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007, Nortel Networks
.
"Introduction" (page 61)
"Configure the Media Gateway Controller on the Call Server" (page 61)
"Configure the Media Gateway Controller" (page 64)
"Configure DSP daughterboards" (page 68)
You must configure the MGC on the Call Server.
You must configure the MGC itself.
Procedure 12 "Configuring the Media Gateway Controller on a Call
Server using LD 97" (page 62)
Procedure 12 "Configuring the Media Gateway Controller on a Call
Server using LD 97" (page 62)
Nortel Communication Server 1000
NN43041-311 01.01 Standard
Release 5.0 30 May 2007
61