Table of Contents
Advertisement
Installing the serial COM port
The procedure to install serial COM port to Riser 3 or 4 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air shroud
NOTE:
The serial COM port is supported only in slot 4 or slot 8 of the expansion card riser.
4.
Remove expansion card
5. If required, remove PCIe card from slot 7.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the serial COM port into the expansion card riser and close the latch.
Figure 152. Installing the serial COM port
3. Connect the serial COM port cable to the rear I/O board.
4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated
on the system board connector.
6. Tighten the captive screws on the system.
Safety
instructions.
Before working inside your
or
remove the GPU air
shroud.
riser.
system.
Installing and removing system components
159
Advertisement
Table of Contents
