Table 62 - Air Configuration Example - Honeywell SmartLine Multivariable SMV800 Series User Manual

Step
1
Select a template for the SMV 3000 model you have for your flow
application.
Select Standard Volumetric flow in the Algorithm field of the FlowAlg
tab and then select the Engineering Units (CFM) on the FlowConf tab
card.
2
Click the
access the Flow Compensation Wizard Equation Model page.
3
Select Dynamic Corrections from the list box on the Equation Model
page of the Flow Compensation Wizard to invoke the Dynamic Flow
Compensation Model, then click
Properties page.
4
Enter the relevant information from the Orifice Sizing Data Sheet in
each entry field of the Flow Element Properties page:
Click
5
Select the fluid state as Gas from the list box on the Fluid State page,
then click
6
Select Standard Volume as the type of gas flow from the list box on
the Gas Flow page, then click
7
Select AIR as the type of fluid from the list box on the Fluid page,
then click
8
Enter the relevant information from the Orifice Sizing Data Sheet in each
entry field of the Pipe Properties page:
Click
Revision 6.0

Table 62 - Air Configuration Example

on the SCT/SMV 3000 configuration window to
Wizard . . .
Element Type
Bore Diameter
Material
Flowing Temperature = 60°F

The expansion coefficient is automatically calculated based
on the entered data.
to proceed to the Fluid State page.
Next
to proceed to the Gas Flow page.
Next
to proceed to the Pipe Properties page.
Next
Pipe Schedule
Nominal diameter
Material

The actual diameter and thermal expansion coefficient for the
pipe are automatically calculated based on the entered data.
to proceed to the Discharge Coefficient page.
Next
SMV800 Transmitter User's Manual
Action
to proceed to the Flow Element
Next
= Flange tap
(D Greater than 2.3 inches)
= 1. 5698 inches
= 304 SS
to proceed to the Fluid page.
Next
= 40s
= 3 inches
= Carbon Steel
Page 283