Honeywell SmartLine Multivariable SMV800 Series User Manual page 114

Group Parameter
KUser/Flow
coeff./Calib.
factor(Fc)
VCone / Wafer Cone
Qmax(VCone)/
Fs(Cond.
orifice)
Max Diff
Pressure
Sizing
VCone_DPmax
VCone Y
Method
Specific
VCone
flow
Simplified
element
Liquid
properties
Pipe
Properties
(GOST std)
Pipe
Roughness(Go
st)/Beta
Factor(WEDGE
)
Radius(Gost)/S
egmentHeight(
WEDGE)
Inter Corner
Interval_Ty
Conditional
Qmax(VCone)/
Fs(Cond.
orifice)
KUser/Flow
coeff./Calib.
factor(Fc)
Page 102
Values
McCrometer/ASME
ON/OFF
year
SMV800 Series HART/DE Option User's Manual
device will calculate the value. See
the below parameter.
Description
Flow Coefficient for WEDGE. This
parameter represents values based
on Algorithm Option and Flow
Calculation Standard. Advanced
Algorithms: For WEDGE, Averaging
Pitot Tube and Integral Orifice, this
parameter represents Flow
Coefficient.
Maximum Flow rate sizing VCone.
For VCone, this parameter along with
Pmax will be used in simplified liquid
calculation when VCone Simplified
Liquid Bit is checked and flow
calculation standard is
VCONE/WAFER CONE
Enter Maximum Differential
Pressure on Sizing VCone in the
units inH2O@39degF
Select the method for calculating the
Gas Expansion factor (Y) used in
Flow calculation
Enter interior wall roughness of the
pipe in the selected unit in the Units
Configuration screen
Pipe Roughness for Gost standard
Configurable when Flow Calc Std is
GOST or WEDGE.
For GOST algorithm type this
represents Initial radius. Enter the
value in mm.
Inspection Period (Orifice/Probe)
Sets, in years
Pipe schedule factor for Conditional
orifice.
Calibration factor Fc
Revision 6.0