Table 21 - Flow Calculation Setup - Honeywell SmartLine Multivariable SMV800 Series User Manual

Pages Group
Flow
Flow Output
Calculation
selections
setup
Advanced
Flow Setup
Simulation
Ranges /
Total Flow
Limits
Page 74
Parameter
Totalizer Unit
Totalizer Value
SMV800 Series HART/DE Option User's Manual
Description
This Page is populated in a DD Host.
See

Table 21 - Flow Calculation Setup

parameters
This Page is populated in a DTM Host
See Using DTMs for details
See Table 21 - Flow Calculation Setup
parameters Failsafe, Reverse Flow,
Simulation
When Flow output type is Mass Flow,
Totalizer Unit lists:

Kg

G

ShTons

LTons

Mton

Lb

Ounce

Custom Unit
When Flow Output type is Volume Flow,
Totalizer units lists:

M3

Barrels

Ft3

Nm3

nLiters

Liters

scft

Scm

Gallons

Custom Unit
When Custom Unit is selected, related
parameters will be enabled:

Custom Unit Tag

Base Unit
Base per Custom Unit Conversion factor
This is the user-configured engineering unit
for the Totalized Value. The user may select
any of the standard engineering units, or
custom units may be selected. For custom
units, the user must provide a units tag name,
a base unit, and a conversion factor for
converting from the base unit to the custom
unit.
(value in Custom unit =value in base unit *
conversion factor)
This is the Totalized Flow as calculated based
on the flow rate during the time that the
Totalizer is in Run mode. The Totalizer will
increment during Forward (positive) flow and
decrement during Reverse (negative) flow.
Note: the Reverse Flow configuration setting
must be enabled to calculate negative flow.
Revision 6.0