Honeywell SmartLine Multivariable SMV800 Series User Manual page 193

Group Parameter
Manual
Input
Viscosity
Flowing
viscosity
Fluid
viscosity
Viscosity
Coefficient_
V#
Lower
TempLimit
Viscosity
TuMin
Upper
TempLimit
Viscosity
TuMax
Revision 6.0
Values
ON
OFF
V1 to V5
SMV800 Series HART/DE Option User's Manual
Description
Applicable When Algorithm Option =
Advanced Algorithms
Manual input flowing viscosity: If viscosity
value is available in the Flow element
calculation report, check manual input and
enter the value. Otherwise uncheck manual
input, and viscosity coefficients will be auto-
calculated for the selected fluid under Fluid
list. Device will calculate viscosity using the
viscosity coefficients. Manual input available
for Advanced algorithms only.
Flowing Viscosity: For Advanced Algorithms,
check Manual i/p Viscosity parameter to
manually enter the value; uncheck, to have
the tool auto-calculate the Viscosity
coefficients based on the selected fluid name.
Device will calculate the flowing Viscosity
using Viscosity coefficients.\n"
"For ASME 1989/Legacy SMV3000
algorithms, no manual input option available.
Always Viscosity coefficients are used to
calculate the flowing Viscosity
See
Table 42 - Viscosity Coefficients:
Dependency to Algorithm
Equation Model and Fluid Type
Auto calculated for selected fluid when
Manual Input Viscosity Switch is unchecked &
fluid name is not 'Custom fluid'. Generally,
any user required fluid should fall into one of
the fluid names listed under fluid list.
However, if a required fluid is not in the list,
user can select 'Custom fluid' and enter the
coefficient value.
Minimum Temperature to select the initial
Temperature vs Viscosity value in the
polynomial equation for auto calculation of
Viscosity. Enter the temperature value in the
units selected in the Unit Configuration
screen.
Lower Temperature limit to calculate the
viscosity. Configurable when Manual Input
Viscosity Switch is unchecked
Maximum Temperature to select the end
point Temperature vs Viscosity value in the
polynomial equation for auto calculation of
Viscosity. Enter the temperature value in the
units selected in the Unit Configuration
screen.
Upper Temperature limit to calculate the
viscosity. Configurable when Manual Input
Viscosity Switch is unchecked
option
Page 181