Cooktop Panel Lock; Wipe Protection; Energy Consumption Display; Power Limitation - Thermador Professional Pro Harmony Series Use And Care Manual

8.13 Cooktop panel lock
You can use the panel lock to prevent the cooktop from
being turned on accidentally.
CAUTION
The panel lock may be turned on and off accidentally due
to:
water spilled during cleaning
▶
food that has overflowed
▶
objects being placed on the panel lock touch key.
▶
Activating the panel lock
Requirement: The cooktop is turned off.
Touch LOCK for 4 seconds.
▶
The indicator over LOCK lights up for 10 seconds.
a
The control panel is locked.
a
Deactivating the panel lock
Touch LOCK for 4 seconds.
▶
The control panel is unlocked.
a
Automatic panel lock
This function automatically activates the panel lock when
you switch off the cooktop.
The automatic panel lock can be activated in the basic
settings.
8.14 Wipe protection
With this function you can avoid changing the settings
while cleaning the control panel during cooking.
This function does not lock the main switch. You can turn
the cooktop off at any time.
Activating the wipe protection
Press LOCK/LOCK.
▶
The indicator above the panel lock key lights up.
a
The control panel is locked for 35 seconds.
a
After 30 seconds a beep indicates that the wipe
a
protection is about to turn off.
Deactivating the wipe protection
Press LOCK/LOCK.
▶
The indicator above the panel lock key goes out.
a
8.15 Energy consumption display
This function indicates the total amount of energy
consumed between turning the cooktop on and turning it
off again.
Once cooktop is turned off, the energy consumption is
displayed in kWh for 10 seconds, e.g. 1.08 kWh. The
accuracy of the display depends on various factors such
as the voltage quality of the power supply.
You can activate or deactivate this function in the basic
settings menu.
8.16 Power limitation
You can use the PowerManager function to set the total
power of the cooktop.
The cooktop is set at the factory; the cooktop's maximum
power is shown on the rating label. You can use this
function to adjust the configuration to the requirements of
each electrical installation.
In order to not exceed this set value, the cooktop
automatically distributes the available power as needed
between the cooking zones that are switched on.
While this function is activated, the output of each cooking
zone may temporarily fall below the nominal value. In
order to not exceed this set value, the cooktop
automatically distributes the available power as needed
between the cooking zones that are switched on . The
appliance regulates and selects the highest power level
automatically.
For more information, refer to the basic settings section.
→ Page 39
8.17 Basic Settings - Cooktop
You can configure the basic settings for your appliance to
meet your needs.
Cooktop basic settings overview
Here you can find an overview of the basic settings and
the preset factory settings.
Display Function
Panel lock
– Manual
1
– Automatic
– Function deactivated
Signal tones
– Confirmation signal and error signal are
off. The main switch signal remains on.
– Only error signal is on.
– Only confirmation signal is on.
– Confirmation signal and error signal are
on .
1
Display energy consumption
– Deactivated
– Activated
Duration of timer end signal
– 10 seconds
– 30 seconds
– 1 minute
⁠ ⁠ Power management function. Limiting the
total power of the cooktop. The available
settings depend on the maximum power of
the cooktop.
– Deactivated
– 1.000 W minimum power
– 1.500 W
Factory setting
1
Factory setting (may vary according to model)
2
Cooktop operation en-us
1
1
,
2
39