Thermador Professional Pro Harmony Series Use And Care Manual page 54

en-us Troubleshooting
Issue
The cookware produces a
crackling noise.
Additional information
Notes
If lights up on the display, press and hold the touch
¡
key for the cooking zone in question, in order to read
the fault code.
Testing cookware suitability
With this function you can check the speed and quality of
the cooking process for individual pieces of cookware.
Requirements
The cookware is cold.
¡
You have read the recommendations for induction
¡
cooking.
Fill the cookware with approximately 8 oz. (200 ml) of
1.
water.
Place the cookware on the cooking zone that best
2.
matches the base of the cookware. Center the
cookware on the cooking zone.
Possible Results for Cookware Suitability Test
There are three possible outcomes for the cookware
suitability test.
Dis Meaning
pla
y
The cookware is not suitable for the cooking zone.
It will not heat up.
If possible, test the cookware again on a smaller
cooking zone.
Noises
Question
Why I can hear noises while
I'm cooking?
54
Cause and troubleshooting
The cookware is made from different multilayered materials
Refer to the section on Cooking with Induction to learn more about suitable
▶
cookware.
You are using cookware of different sizes and different materials.
Refer to the section on Cooking with Induction to learn more about suitable
▶
cookware.
Answer
Noises may be generated while using the cooktop depending on the properties of the
¡
base of the cookware. These noises are normal for induction technology. They do not
indicate that there is a fault.
If the fault code is not listed in the table, disconnect the
¡
cooktop from the power supply, wait 30 seconds, and
then reconnect it again. If the display appears again,
contact Customer Support and tell them the precise
fault code.
If a fault occurs, the appliance will not switch to standby
¡
mode.
If the diameter of the cooking zone is much smaller than
the diameter of the cookware, only the middle of the
cookware will heat up. This may have a negative effect
on the cooking results.
Select in the basic settings.
3.
Touch any control element in the settings range.
4.
flashes in the cooking zone display.
a
The result of the test appears in the cooking zone
a
display after 10 seconds.
→ "Possible Results for Cookware Suitability Test",
Page 54
Note: The flexible cooking zone only counts as a single
cooking zone; place no more than one item of cookware
on it.
Dis Meaning
pla
y
The cookware takes longer than expected to heat
up. The cooking process is not ideal.
If possible, test the cookware again on a smaller
cooking zone.
The cookware heats up correctly. The cooking
process is good.