Epson Stylus Pro 10000 Service Manual page 356

EPSON Stylus Pro 10000/10000CF/10600
Table 8-40. Paper information (MENU P)
Item
Paper ejection times of each paper size
(Sheet width 5)
Print length of each paper size (Sheet width 6)
Paper ejection times of each paper size
(Sheet width 6)
Print length of each paper size (Sheet width 7)
Paper ejection times of each paper size
(Sheet width 7)
Print length of each paper size (Sheet width 8)
Paper ejection times of each paper size
(Sheet width 8)
Print length of each paper size (Sheet width 9)
Paper ejection times of each paper size
(Sheet width 9)
Print length of each paper size (Sheet width 10)
Paper ejection times of each paper size
(Sheet width 10)
NOTE1: Roll paper width XX, Sheet width XX are as follows;
more than 1018mm~less than 210mm is classified into 10 categories at
100mm intervals.
NOTE1: Paper width in MENU P is the set paper width by ESC (S command.
If set paper is narrower than set paper width here, the set paper width
is used.
Stylus Pro 10600
Thank You For Using TheServiceManualShop.com
Panel Display Setup Values
P32 <nnnnnnnnn>
P33 <nnnnnnnnn>
P34 <nnnnnnnnn>
P35 <nnnnnnnnn>
P36 <nnnnnnnnn>
P37 <nnnnnnnnn>
P38 <nnnnnnnnn>
P39 <nnnnnnnnn>
P40 <nnnnnnnnn>
P41 <nnnnnnnnn>
P42 <nnnnnnnnn>
Thank You For Using TheServiceManualShop.com
Product Description
Print mode
Table 8-41. Print mode (MENU M)
Item
Print mode setting times 1440-720
Print mode setting times 720-720
Print mode setting times 720-360
Print mode setting times 360-720
Print mode setting times 360-380
Print mode setting times Others
Print mode setting times 1440-720
Print mode setting times 720-720
Print mode setting times 720-360
Print mode setting times 360-720
Print mode setting times 360-360
Print mode setting times Others
Panel setup information
Table 8-42. Panel setup information (MENU O)
Item
PG setting change times
Roll paper margin change times
Nozzle check patter print times
Final nozzle check pattern print date
Job information print times
Final job information print date
User paper No. change times
Cut pressure change times
Cut method change times
Revision D
Panel Display Setup Values
Uni-D
M1 <nnnnnnnnn>
Uni-D M2 <nnnnnnnnn>
Uni-D M3 <nnnnnnnnn>
Uni-D
M4 <nnnnnnnnn>
Uni-D
M5 <nnnnnnnnn>
Uni-D
M6 <nnnnnnnnn>
Bi-D M7 <nnnnnnnnn>
Bi-D M8 <nnnnnnnnn>
Bi-D
M9 <nnnnnnnnn>
Bi-D
M10 <nnnnnnnnn>
Bi-D
M11 <nnnnnnnnn>
Bi-D M12 <nnnnnnnnn>
Panel Display Setup Values
O1 <nnnnnnnnn>
O2 <nnnnnnnnn>
O3 <nnnnnnnnn>
O4 <YY><MM><DD>
O5 <nnnnnnnnn>
O6 <YY><MM><DD>
O7 <nnnnnnnnn>
O8 <nnnnnnnnn>
O9 <nnnnnnnnn>
349