Epson Stylus Pro 10000 Service Manual page 276

EPSON Stylus Pro 10000/10000CF/10600
Figure 6-3. Operation Panel
*1 : Confirm that there are dot missing at the time of the nozzle checking pattern
printing. In the case that the abnormality was admitted pushing the cleaning switch for
3 seconds, and the head cleaning (about 2 minutes : Until the printing passable lamp
changes to the inspection from the flickering) is run. The nozzle checking tries to be
run once again hereafter.
Good example
*2 : Use the status sheet as for the confirmation of the part life (the exchange time) that
showed in the Table 6 -2, because the status sheet prints the information that showed in
the Table 6 -3.
Maintenance
Thank You For Using TheServiceManualShop.com
Bad example
Figure 6-4.
Thank You For Using TheServiceManualShop.com
General Maintenance Issues
Table 6-3. Status sheet
Item Panel display
Version of the firmware VERSION
Before page ink used quantity INK
Printing number of sheets (C).
PRINTABLE SHEET
Printing number of sheets (M)
PRINTABLE SHEET
Printing number of sheets (LC)
PRINTABLE SHEET
Printing number of sheets (LM)
PRINTABLE SHEET
Printing number of sheets (Y)
PRINTABLE SHEET
Printing number of sheets (K) PAGE COUNT
Accumulation ink consumption
TOTAL INK
volume
Accumulation paper
PAPER COUNT xxxxxxx cm
consumption volume
INK COUNTER
Ink counter clear
CLEAR
PAPER
Paper counter clear COUNTER
CLEAR
Revision D
Setting value Contents
The firmware version of the
TOxxxx. yyyy .zzzz
printer is displayed.
The ink used quantity in the page
xx.x g that printed in immediately before
is displayed.
Whether is displayed additional
how many sheets of printing
possibility, on the basis of the ink
used quantity in the page that
printed it in immediately before
every the ink.
xxxxxxx sheet
C : Cyan
M : Magenta
LC : Light cyan
LM : Light magenta
Y : Yellow
K: Black
The used quantity of the ink is
xxxxxxx.x g
displayed with "g" unit.
The length of the form that used it
is displayed with "cm" unit.
The ink counter is initialized in 0.
The consumption volume of the
Run
ink in an optional printed matter
can be instrumented with [Ink
counter] and [Ink counter clear].
The form counter is initialized in
0.
The used quantity of the form in
Run
an optional printed matter can be
instrumented with the [form
counter] and [form counter clear].
269