Epson Stylus Pro 10000 Service Manual page 44

EPSON Stylus Pro 10000/10000CF/10600
INTERFACE SELECT
Selecting this mode allows selection of the parallel / USB, or optional interface-1 /
2, or automatic interface selection.
CODE PAGE SWITCHING
Selecting this mode allows switching between PC437 and PC850 for the code
page.
ROLL PAPER MARGIN
Setting this panel allows switching roll paper margin, all sides 3mm / all sides
15mm / top and bottom 15mm, right and left 3mm. This setting is only valid for
roll paper. It's not valid for sheet.
This setting change only margin, and doesn't change image size.
(1) If margin=3mm is set
Printing positions of vertical line and horizontal line are same as paper size.
(2) If margin=15mm, or Top/Bottom15mm is set
Printing positions of vertical line and horizontal line are positions widened 12mm
for all sides or top and bottom.
PAPER SIZE CHECK
It restrains "RELOAD PAPER" error in case detecting paper width is not
completed normally, and prints with
• left edge of paper putting standard mark position on the paper guide
• print area designated by command
by PAPER SIZE CHK=OFF setting.
It is used for printing with paper that can't be detected for low reflectance like
tracing paper and so on.
When it print bigger image than set paper by this setting, it may print on the platen.
Users change the setting at that time.
NOTE: It occurs error when detection of the top of paper is failed.
Product Description
Thank You For Using TheServiceManualShop.com
DETECT SKEW ERROR
It restrains "PAPER NOT STRAIGHT" error and keeps printing by PAPER NOT
STRAIGHT=OFF setting.
Even if the printing image is out of paper because the paper is not straight by the
setting, the printer doesn't inform the error, so users have to set up it.
PANEL SETUP VALUE INITIALIZATION
Selecting this mode allows the user to return all values set from the panel to be
returned to the default values.
Thank You For Using TheServiceManualShop.com
SelecType Settings
Revision D
37