Configuring An Individual Access Point - Nortel BayStack 660 Use Manual

Using the BayStack 660 Wireless LAN Access Point
Note: If this is the first time you have opened the AP Manager, an IP address
request window may open. Go to
more information.
The AP Manager window provides the menus and commands shown in
Table 4-1.
Items
File
Edit
Configure
Actions
View
Tools
Help

Configuring an Individual Access Point

After the AP Manager software is loaded and the access point has been assigned
an IP address, you should configure the access point. Access points "discovered"
on the subnet are displayed in the Access Point dialog box
may take a few seconds for your access point to display.
4-6
"Adding a New IP Address" on page 4-3
AP Manager Menus and Commands
Command Description
Exit Closes the AP Manager.
Groups Creates and edits Groups.
Adapter List Creates and edits Adapter Lists.
Quick list Configures access points assigned to the quick list.
Group Configures access points assigned to a group.
Access Points Configures access points.
Quick list Performs actions on access points assigned to the
quick list.
Group Performs actions on access points assigned to a group.
Access Points Performs actions on an access point.
Activity Displays the activity of an access point.
Access Point Displays the status of access points.
Find Listed Finds an adapter assigned to the adapter list.
Adapter
Find Adapter Finds an adapter.
WEP Configures WEP security for an access point.
BOOTP Edits the BOOTP table.
About Displays the version of the AP Manager program.
for
Table 4-1.
(Figure 4-4). Note: It
203939-B