Nortel BayStack 660 Use Manual page 86

Using the BayStack 660 Wireless LAN Access Point
•
•
•
•
•
•
•
•
The parameters are changed for every access point in a group. Depending on the
options selected, a series of dialog boxes may open requesting new information.
The following section describes each of these options.
Changing the ESSID
To change the ESSID (Extended Service Set Identification):
Choose Configure > Group.
1.
Select the group you want to configure.
2.
The Multiple Configuration Wizard dialog box
Click ESSID.
3.
Click Next.
4.
The ESSID dialog box opens.
Enter a new ESSID of up to 32 alphanumeric characters.
5.
Click Next.
6.
A confirmation dialog box opens asking if the changes you made are correct.
4-30
To set the hop sequence to auto-negotiate, go to
Auto-Negotiate Hop Sequence (FH)" on page 4-34
To set the channel (DS), go to
To set the translation mode, go to
4-35
To set the authorized station list, go to
List" on page 4-36
To enable the authorized station list, go to
Station List" on page 4-38
To set the maximum concurrent users, go to
Concurrent Users" on page 4-39
To set the WEP parameters, go to
page 4-40
To set the expert parameters, go to
"Enabling
"Setting the Channel (DS)" on page 4-35
"Setting the Translation Mode" on page
"Setting the Authorized Station
"Enabling the Authorized
"Setting the Maximum
"Setting the WEP Configuration" on
"Expert Parameters" on page 4-41
(Figure 4-15) opens.
203939-B