Cli Command List; Table 6-1. Cli Command List - Nortel BayStack 660 Use Manual

CLI Command List

Table 6-1
table lists a page number where you can find more information.
Table 6-1.
Commands and Descriptions
ACL commands— Use these commands to add/delete Access Control
List (ACL) entries and to display the list.
acl add < mac_addr >
acl control {on | off}
acl delete < mac_addr >
acl show
Adapter commands— Use these commands to upgrade the adapter's
firmware and to display the adapter's attributes.
adpt load-image < file_name > < ip_addr >
adpt show
AUL commands— Use these commands to configure the Associated
Users List (AUL) and to display the list.
aul limit < num_mus >
aul show
Authentication commands— Use these commands to configure/display
authentication scheme attributes.
auth open-system {on | off}
auth shared-key {on | off}
auth show
Configuration commands— Use these commands to restore factory
default configuration and to save current configuration to flash.
config reset
config save
Encapsulation commands— Use these commands to configure/display
encapsulation attributes.
encap scheme {straight | 802.1h+NTISTT}
encap show
203939-B
lists and describes the commands in the CLI. For most commands, the
CLI Command List
Command Line Interface
Page Number
Go to page 6-6
Go to page 6-8
Go to page 6-9
Go to page 6-10
Go to page 6-11
Go to page 6-11
6-3