Change Password; Firmware Upgrade; Restore Factory Settings; Reset Access Point - Nortel 2221 Product Manual

Change Password

Use this section to change the password on the access point

Firmware Upgrade

Note: You must disable the radios prior to upgrading the Access Point
2220/2221 or the upgrade may not occur.
Local - Click "Browse" to locate the downloaded firmware file and click "Start
Upgrade" to start the upgrade process.
Remote - Select FTP or TFTP, and enter firmware file name, the host IP address,
user name, and password. (You need your user name and password only with the
FTP.) Click "Start Upgrade" to start the upgrade process.
For latest firmware version information, go to the Nortel Networks customer
support web site at: http://support.nortelnetworks.com/, select "Wireless LAN"
and then "WLAN Access Point 2220" or "WLAN Access Point 2221" and then
"Software."

Restore Factory Settings

Click the "Restore" button to load the factory default configuration and reboot this
device. Note that all user configured information will be lost. You will also have to
re-enter the default user name (nortel) to regain management access to this device.

Reset Access Point

Clicking on the "Reset" button to perform a hardware reset of the access point.
Note: Although current configurations will not be changed, you must
reset the time. (The default time setting is January 1 at midnight.)
Using the Nortel Networks Wireless LAN Access Point 2220/2221
Chapter 3 System Configuration
(Figure
43
18).