Nortel BayStack 660 Use Manual page 160

BOOTP Restrictions dialog box, 5-16
BOOTP Table
description, 5-12
BSA, description, 1-10
BSS Rates field, 4-12
building, small, 1-4
C
cable, required, 3-2
Carrier Sense Multiple Access/Collision Avoidance.
See CSMA/CA
Change BOOTP Entry dialog box, 5-14
Change Group dialog box, 4-27
channel
separation, 1-2, 1-3
channelized services, 1-2
Choose Install Folder dialog box, 4-2
clear to send. See CTS
CLI
accessing, 6-1
command list, 6-3
collision detection, virtual, 1-6
collisions, 1-8
command, 6-4
command line interface. see CLI, 6-1
configuration commands, 6-11
conventions, text, xviii
coverage area, verifying, 2-13
CSMA/CA, 1-7
CTS, 1-7
customer support, xx
D
Data Link layer, 1-6
data transmission, indicated by LED, 2-8
default SSID, 2-8, 3-5
diagnostics, 7-1
Direct Sequence Spread Spectrum.
Index-2
See DSSS
drivers, location, 1-8
DSSS signal modulation, 1-2
DTIM Period field, 4-14
dynamic IP configuration, 4-4
E
Enable WEP Encryption check box, 4-21
Enabling Authorized Station List, 4-38
encapsulation commands, 6-11
equipment, required for site survey, 2-1
error detection, 1-6
ESSID
changing, 4-30
field, 4-10
setting, 6-20
Ethernet Configuration field, 4-14
Ethernet segment, 1-11
expert parameter, 4-41
extended service erea (ESA)
estimating during planning, 2-4
F
fail-over commands, 6-12
Failover Control field, 4-14
features, 1-1
Find Adapter dialog box, 5-4
floor plans, reviewing, 2-3
Fragmentation Threshold field, 4-14
frequency spectrum for Physical layer, 1-7
G
gateway
changing, 4-31
Gateway field, 4-10
group
configuring in quick list, 4-28
displaying in quick list, 4-28
viewing, 4-26
203939-B