Command Line Interface; Accessing The Cli - Nortel BayStack 660 Use Manual

This chapter describes the CLI (Command Line Interface) and its command
syntax. The BayStack 660 Access Points CLI enables you to display and modify
access point configurations. The CLI provides additional features available
through the AP Manager. Go to
Manager" for more information on the AP Manager.
You access the CLI through Telnet in order to display and modify configurations
while the BayStack 660 Access Point is running. The access point supports only
one Telnet session at a time.

Accessing the CLI

In order to access the CLI, you must enable Telnet access on the specific BayStack
access point.
To enable Telnet access:
1.
2.
3.
4.
5.
203939-B
From Windows taskbar, choose Start > Programs > BayStack AP
Manager > BayStack AP Manager.
The BayStack AP Manager opens.
Choose Configure > Access Point.
The Access Point dialog box opens.
Click the access point that you want to configure.
Click Configure.
The Configuration dialog box opens with the Basic tab selected.
Check the Enable Telnet Access check box.

Command Line Interface

Chapter 4, "Installing and Starting the AP
Chapter 6
6-1