Installing and connecting a Series
2332 Access Point
Unpacking an AP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Installation requirements and recommendations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Installing a Series 2332 access point . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Connecting an AP to a WSS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53
Verifying AP health . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
Note.
Before installing an AP, you might need to generate a network plan and an AP
work order with WLAN Management Software . (See
network plan and work orders" on page
Unpacking an AP
The shipping carton for an AP contains the following items:
•
One AP
•
Mounting kit:
•
One universal mounting bracket (attached to the AP)
•
One paper mounting template (used for marking the cutting areas and screw hole locations)
•
One two-piece 14.2-mm (9/16-inch) T-bar clamp
•
One two-piece 15.9-mm (5/8-inch) T-bar clamp
•
One two-piece 23.9-mm (15/16-inch) T-bar clamp
•
Two #6 sheet metal screws and two drywall anchors
•
Three adhesive rubber feet
•
One documentation pack that includes the following documents:
•
Nortel WLAN Series 2332 Access Point Quick Installation Guide
•
Nortel WLAN 2300 Series Access Point Mounting Template
•
Nortel WLAN 2300 Series Outdoor Solution Guide
"WLAN Management software
32.)
Nortel WLAN Series 2332 Access Point Installation Guide
31